[Documentation] [TitleIndex] [WordIndex

Only released in EOL distros:  

Package Summary

Integrated package that allows PR2 teleoperation with force feedback using two Phantom Omni devices and the stereo_anaglyph viewer.

Requirements

Running

Prior to running the teleop package, pull out the Omni pens from its calibration wells.

On the first computer (I use a laptop for this) connected to a Phantom Omni:

rosrun phantom_omni omni2.sh

Now place omni2's tip back into its calibration well. This will control the PR2's left arm.

On the second computer, also connected to an Omni:

roslaunch pr2_omni_teleop stereo_omni_pr2.launch

Now, place the right omni's tip back into its calibration well. Open rosconsole on pr2_dashboard.

User Interface

Adjust the stereo separation with your left and right arrow keys. Then with both the pens in their calibration well, pull the pens out slowly. The Omni's should now be applying a force guiding you to a point in its workspace. This point is the location of the PR2's end effector in the Omni's workspace. After you have moved to the bottom of this potential well, activate position control of the PR2 by pressing the grey and darker grey button on the Omni's pen simultaneously (on either Omni but NOT on both Omni's at once). While running, pressing the dark grey button will close the gripper and pressing the light grey button will open it. The PR2's head also does not need to be repositioned as it will always track the center point of the two grippers.

To turn off position control, press both the grey and dark grey button simultaneously (again, on either Omni but NOT both). Push the pens back into their calibration well.

Beta Version Warning

The controllers applying the potential well have been updated and seem very stable. Force feedback has been implemented and can be launched using the ff_omni_pr2.launch file. This allows you specify the arm you want to control (left or right) and whether or not to activate force feedback. The force feedback is currently a position position architecture. Moving the omni stylus quickly with force feedback activated will cause you to feel the inertia inherent in moving the gripper of the PR2 quickly. If you release the stylus while moving quickly, the omni stylus may go unstable.

track_gripper.py

This node will track the midpoint of the line joining the PR2's gripper tips, allowing the user to not have to worry about controlling the PR2's pantilt unit during teleoperation. It is also independent of the pr2_omni_teleop package. To use it run:

rosrun pr2_omni_teleop track_gripper.py

2019-10-19 13:02